适用于MMC型直流变压器的直流故障主动限流控制方法

DING Ran

您当前的位置：

首页 >

文章列表页 >

适用于MMC型直流变压器的直流故障主动限流控制方法

更新时间：2025-08-13

- 适用于MMC型直流变压器的直流故障主动限流控制方法
- Automation of Electric Power Systems Vol. 42, Issue 21, Pages: 131-138(2018)
- 作者机构：
  
  东南大学电气工程学院,江苏省,南京市,210096
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2018
- 稿件说明：
移动端阅览
DING Ran. [J]. Automation of electric power systems, 2018, 42(21): 131-138.
DOI：

DING Ran. [J]. Automation of electric power systems, 2018, 42(21): 131-138. DOI：

摘要

为满足模块化多电平换流器(MMC)型直流变压器对直流故障电流快速限制的要求，有必要对其主动限流控制方法进行研究。文中通过对双极短路故障机理的详细分析和故障电流的建模，得到了考虑上升阶段交流馈入量后的桥臂电流，以及短路电流峰值和峰值时间的表达式，然后给出了可以通过降低在故障发生后每相子模块投入数量来限制故障电流的结论。基于此结论，设计了一种新型主动限流控制方法。该方法通过产生附加直流偏置和交流增益，进而调整桥臂电压的直流分量和交流分量，再经调制环节达到限流目的。最后通过仿真验证了所提出方法的有效性和优越性。

Abstract

In order to meet the requirements of fast current limiting of DC fault for modular multilevel converter(MMC)based DC transformer

the research of active current limiting control is necessary. By a detailed analysis of DC pole-to-pole fault mechanism and modeling of the fault current

the expressions of arm currents considering the feed at rising stage

the peak current and the peak time of short-circuit current are derived

then the conclusion that the fault current can be limited by reducing the number of submodules to switch on at each phase after DC fault is obtained. According to this conclusion

a novel active current limiting control method is proposed. By producing additional DC offset and AC gain

the DC component and AC component of the bridge-arm voltage are adjusted to achieve the purpose of current limiting through the modulation process. Finally

the simulation results verify the effectiveness and superiority of the proposed method.

关键词

Keywords

references

Views

2607

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Fast Protection Scheme for Bipolar Face-to-face Modular Multilevel Converter Based DC Transformer

Topology and Control Strategy of Split-phase Cascaded High-voltage Large-capacity DC Transformer

Continuation Power Flow Calculation for DC Distribution Network Considering Control and Capacity Constraints of DC Transformer

Related Author

LIAO Jianquan

HU Chengbin

GAO Shilin

TAN Zipeng

WANG Yuhong

WU Xiaodan

YIN Zihan

ZHU Haiyong

Related Institution

College of Electrical Engineering, Sichuan University

NR Electric Co., Ltd.

NARI Group Corporation(State Grid Electric Power Research Institute)

State Key Laboratory of Power Transmission Equipment Technology (Chongqing University)

College of Electric Engineering, Sichuan University

⁰