铁磁谐振在调度端的典型特征

SHI Wenjiang

您当前的位置：

首页 >

文章列表页 >

铁磁谐振在调度端的典型特征

更新时间：2025-08-13

- 铁磁谐振在调度端的典型特征
- Automation of Electric Power Systems Vol. 39, Issue 7, Pages: 194-197(2015)
- 作者机构：
  
  国网大连供电公司,辽宁省,大连市,116011
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2015
- 稿件说明：
移动端阅览
SHI Wenjiang. [J]. Automation of electric power systems, 2015, 39(7): 194-197.
DOI：

SHI Wenjiang. [J]. Automation of electric power systems, 2015, 39(7): 194-197. DOI：

摘要

小电流接地系统的铁磁谐振事故在调度端的典型特征为中性点零序电压(3U0)越限报警信号的“动作／复归”多次成对出现;母线电压中有两相呈现为0或1.2倍线电压(遥测满码溢出);故障母线上的所有保护装置告警信号的“动作／复归”多次成对出现;相邻母线伴随出现耦合谐振、消弧线圈的频繁动作信号。这些特征综合起来使铁磁谐振明显有别于单相接地、单相断线故障

有利于谐振事故的快速处理。

Abstract

The typical characteristics of ferroresonance accident happening in a network grounded with arc extinguishing coil are manifested in multiple times by 3U0 off-limit alarm

with two of the three-phase voltage and its historical curve

protection alarm

arc extinguishing alarm information appearing in pairs in the dispatching automation interface. They can be used as the ferroresonance comprehensive criterion

while ferroresonance recognition time is no longer than 10 minutes by the standard identifying process.

关键词

Keywords

references

Views

2173

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Detection and Type Identification of Single-phase Series Ferroresonance in Neutral Point Solid Grounding Power Grid

中性点不接地系统铁磁谐振与单相接地辨识技术

一种小电流接地系统单相接地故障测距新方法

基于零序电流和磁场检测故障杆的配电网故障定位

一种配电网线 — 缆混合线路故障选线新方法

Related Author

Bin WANG

Hai ZHANG

Zongjie LIU

Haipeng ZHU

Bing YUAN

Chao ZHANG

YANG Yihan

DONG Di

Related Institution

School of Electrical and Electronic Engineering, Shandong University of Technology

State Key Laboratory of Power System Operation and Control(Tsinghua University)

Jining Power Supply Company of State Grid Shandong Electric Power Company

North China Electric Power University

Henan Electric Power Survey & Design Institute

⁰